Brake Pads Bedding Procedure

After step 3 your brake pads are ready for normal use.

Brake pads bedding procedure. To bed-in your brake pads begin by applying the brakes at low speeds to assure proper system operation. Allow at least 15 minutes for brake system to cool down. Repeat this process 2-3 times.

Repeat this process 3-4 times to get some heat into the brake pads. After youre complete with bedding your ENDLESS brake pads take a close look at the brake disks. It is very important that this initial layer of.

This process will lay down a thin layer of transfer film on to the rotor surface. Speed Up Then Slow Down. Burn out volatile elements Transfer a layer of friction material onto disc Mechanically align pad surface with disc surface for full contact patch.

Leave at least 1km between each brake. You dont need to come to a complete. Brakes are a critical safety system of a vehicle.

Because of this treatment PBS brake pads only need light bedding in to match the padding to the disc. Split up any long straights with a braking execution to keep the cars maximum speed down while you are performing the bed-in procedure. Repeat around 5-10 times.

Brake rotors dont require as much bedding as brake pads require. The bed-in process leaves a film of brake pad material on the rotor and creates the perfect environment for the ceramic brake pads to grip the rotor and stop your vehicle. PBS brake pads are put through a heat curing treatment in the manufacturing process.