Broken Bed Slat Holders

The 2 rubber pins on the plastic caps are 35mm apart from pin centre point to point and would fit any bed frame rails between approximately 34mm - 36mm.

Broken bed slat holders. White leather queen bed frame base Tufted bedhead Tufted leather bedhead leg board side rails slats and fittings Few slats are abit loose as the slat holders became loose was never noticeable with the heavy mattress on the frame Excellent condition only 2 or 3 slats just needs to be drilled into place then will be good as new Like new luxury queen mattress available if needed for 400 Smoke pet-free. Washers are fair game here. How to replace a Bed-Slat.

The slot or slat holder got pushed in a hole in the bedframe. Just re read the bit about glued in slot all the ones Ive put together. Bed Slat holders are very specific to the bed frame.

Its a queen size bed with two sets of slats each side of a central rail. The trick is to provide a hole big enough that the pins can move a bit but smaller than the heads. 3 May 2011 at 1104AM.

3Plastic End caps for holding and securing wooden slats on the bed base. 5The distance of 2 plastic pins on the plastic caps are 33mm. Just the slat holders.

Old broken booth laying on a bed of sea weed. 4The caps actual inside dimension. 4The caps actual inside dimension.

Shop from the UKs largest selection and best deals for Bed Slats. Some of the people sitting on it are a bit fat. Mechanic unscrewing broken plastic bed slat holders.